All Collections
Broadband Services
Modem Guides
How to Configure Technicolor DMA0120VHA (VBNT-R) Modem
How to Configure Technicolor DMA0120VHA (VBNT-R) Modem

This guide will assist you in connecting your Technicolor DMA0120VHA (VBNT-R) modem to the SpinTel network

Annive avatar
Written by Annive
Updated over a week ago

Is Technicolor DMA0120VHA (VBNT-R) NBN ready?

The Technicolor DMA0120VHA (VBNT-R) is a popular nbn™ modem router that will also work with SpinTel for FTTN/B, FTTC, HFC, FTTP and Fixed Wireless NBN services.

How Do You Connect Your Technicolor DMA0120VHA (VBNT-R) Modem?

Depending on your nbn connection type, connect one of the following:

  • If there is no NBN Connection Box installed, connect the DSL port at the back of your router to your phone wall socket.

  • If there is an NBN Connection Box installed, connect the WAN port at the back of your router to your NBN Connection Box.

  • Connect any of the LAN ports on the back of your router to your PC (optional)

  • Connect the Power port on the back of your router to your power socket

To get connected via your Technicolor DMA0120VHA (VBNT-R) modem, you'll need to log into your modem gateway.

Note: This can be done on most mobile devices, but we recommend doing these steps with your PC if you have one.

How Do You Log in To Your Technicolor DMA0120VHA (VBNT-R)Modem?

To access the modem interface, please make sure your device is connected to your modem through a wired or wireless connection.

1. From your browser, type in 192.168.1.1 in the address bar and hit Enter.

If the IP address does not work or if it has been changed, check your router's IP address. For instructions, click here.

2. Login with the account you set for the modem router, otherwise check the default username and password on the sticker of your modem.

How Do You Set Up Your Technicolor DMA0120VHA (VBNT-R) modem?

Once logged in, click on Settings and select WAN as shown in the image below:

For FTTN/B NBN connection type:

Click the edit icon and configure the WAN VDSL. Change the Protocol to PPPoE then enter the username and password provided to you via email when the order was completed.

For FTTC, HFC, and FW NBN connection type:

Click the edit icon and configure the ETHERNET WAN. Change the Protocol to PPPoE then enter the username and password provided to you via email when the order was completed.

Did this answer your question?