All Collections
Broadband Services
Modem Guides
How to Configure your D-LINK DSL 2878 Modem
How to Configure your D-LINK DSL 2878 Modem

This guide will assist you in connecting your D-LINK DSL 2878 modem to SpinTel network

Liam Bal avatar
Written by Liam Bal
Updated over a week ago

To get connected via your D-LINK modem, you'll need to log into your modem gateway.

Note: This can be done on most mobile devices, but we recommend doing these steps with your PC if you have one.

Logging into your modem

To access modem gateway, enter http://192.168.1.1 in the address bar of a web browser. If the IP address does not work or if it has been changed, check your router's IP address. For instructions, click here.

If prompted with a log in screen, click Log In to proceed. No password is enabled by default. Otherwise, log in with the password you set for the modem router.

Once logged in, the Setup Wizard shows up, click Next to continue

Select your WAN access type: ADSL, VDSL, or Ethernet

Look for SpinTel on the ISP list, otherwise select Not Listed and click Next.

If the router does not detect a valid Internet connection, a list of connection types to choose from will be displayed.

Select PPPoE for the connection type and enter the username and password provided to you via email when the order was completed.

Personalise your WiFi credentials and click on Next. Follow the prompts (details below) until it reaches the Summary page and you're all set.

Click Finish to close the wizard. The device will then reboot.

Wait 3-5 minutes for the modem to go online, then test the service.

Related articles:

Did this answer your question?