To get connected via your BiPAC 8700NEXL R2 modem, you'll need to log into your modem gateway.

Note: This can be done on most mobile devices, but we recommend doing these steps with your PC if you have one.

Logging into your modem

To access modem gateway, enter http://192.168.1.254 in the address bar of a web browser. If the IP address does not work or if it has been changed, check your router's IP address. For instructions, click here.

Enter admin for both the username and password and click OK to login.

If you have changed the login credentials, please enter the current username and password for your modem interface.

Once you have logged on to your BiPAC 8700NEXL R2 Router via your web browser, you can begin to set it up according to your requirements. Follow the steps below to update your ISP credentials.

1. Go to Quick Start and select Ethernet, press Continue to go on to next step.

2. The WAN Type should be PPPoE.

Enter the username and password provided to you via email. Hit Continue

3. Wait while the device is configured. After the configuration is successful, click Next to Wireless button and you may proceed to configure the Wireless setting.

4. Tick Enable for Wireless and set up your SSID and WiFi password. Click Continue to apply. A Success page will show up once done and you're all set!

Wait 3-5 minutes for the modem to go online, then test the service. Reboot modem if needed.

Related articles:

Did this answer your question?