All Collections
Broadband Services
Modem Guides
How to Configure your Netgear D7800 Modem
How to Configure your Netgear D7800 Modem

This guide will assist you in connecting your Netgear D7800 Modem to SpinTel network

Annive avatar
Written by Annive
Updated over a week ago

To get connected via your Netgear modem, you'll need to log into your modem gateway.

Note: This can be done on most mobile devices, but we recommend doing these steps with your PC if you have one.

Logging into your modem

To access modem gateway enter http://www.routerlogin.com in the address bar of a web browser. If it does not work or if it has been changed, check your router's IP address. For instructions, click here.

Use admin for username field and password in the password field then click on Login.

The BASIC Home page displays.

To specify the settings for a cable or fiber Internet connection:

1. Select ADVANCED > Setup > WAN Setup.

From the WAN Preference menu, select Must use Ethernet WAN. By default, the menu selection is Must use DSL WAN.

2. Click the Apply button.

Your settings are saved and the modem router restarts.

Note: If you use a WiFi device to connect to the modem router, you might need to log in again.

3. Select BASIC > Internet

  • From the Select Country menu, select the country in which you use the modem router.

  • From the Select Internet Service Provider menu, look for SpinTel. Otherwise if not listed, choose Other.

  • Make sure that the Enable This Interface check box is selected

  • Scroll down to the Does your Internet connection require a login? section and select the Yes radio button

Enter the username and password provided to you via email.
Click Apply to save the new settings.

Note: If other settings are presented, accept default values

To view or specify the settings for a VDSL Internet connection:

Select BASIC > Internet

  • From the Select Country menu, select the country in which you use the modem router.

  • From the Select Internet Service Provider menu, look for SpinTel. Otherwise if not listed, choose Other.

  • From the Transfer Mode menu, select VDSL(PTM).

When you select VDSL(PTM) from the Transfer Mode menu, the only option in the DSL Mode menu is VDSL2

  • Make sure that the Enable This Interface check box is selected

  • Scroll down to the Does your Internet connection require a login? section and select the Yes radio button

Enter the username and password provided to you via email.
Click Apply to save the new settings.

Wait 3-5 minutes for the modem to go online, then test the service. Reboot modem if needed.

Related articles:

Did this answer your question?