All Collections
Broadband Services
Modem Guides
How to Configure your LINKSYS X6200 Modem
How to Configure your LINKSYS X6200 Modem

This guide will assist you in connecting your LINKSYS X6200 Modem to SpinTel network

Annive avatar
Written by Annive
Updated over a week ago

To get connected via your LINKSYS modem, you'll need to log into your modem gateway.

Note: This can be done on most mobile devices, but we recommend doing these steps with your PC if you have one.

Logging into your modem

To access modem gateway enter http://192.168.1.1 in the address bar of a web browser. If it does not work or if it has been changed, check your router's IP address. For instructions, click here.

Use admin for both username and password field then click on Login.

The web-based setup page of your modem router will then appear.

  • Click on the Quick Start tab and click Launch to start the setup wizard.

The wizard will guide you through the configuration.

  • For manual setup, click on Setup > Basic Setup tab. In the Physical Setting section, select DSL for Physical Type, and PTM for DSL Mode.
    Leave VLAN ID unticked.

Select PPPoE for the Internet Connection type.

Enter the username and password provided to you via email.

Click Save Settings (at the bottom of the page) to save settings and complete setup.

Wait 3-5 minutes for the modem to go online, then test the service. Reboot modem if needed.

Related articles:

Did this answer your question?